Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual page 96

Configuring Asynchronous/Synchronous Serial Interfaces
Task
Step 10
Exit back to global configuration mode.
If your Catalyst 4224 has more that one serial interface that
you need to configure, repeat Step 4 through Step 9.
Step 11 When you finish configuring the interface, return to enable
mode.
Table 4-1 Half-duplex timer commands
Timer
1
CTS delay
CTS drop timeout
2
DCD drop delay
DCD transmission start delay
3
RTS drop delay
RTS timeout
Transmit delay
1. CTS = Clear To Send.
2. DCD = Data Carrier Detect
3. RTS = Request To Send.
Catalyst 4224 Access Gateway Switch Software Configuration Guide
4-8
Table 4-1 lists the half-duplex timer commands.
Syntax
half-duplex timer cts-delay
half-duplex timer
cts-drop-timeout
half-duplex timer
dcd-drop-delay
half-duplex timer
dcd-txstart-delay
half-duplex timer
rts-drop-delay
half-duplex timer
rts-timeout
half-duplex timer
transmit-delay
The following clock rate settings are for two-port asynchronous/synchronous
serial WICs:
1200 bps
•
2400 bps
•
4800 bps
•
9600 bps
•
Chapter 4 Configuring the Data Interfaces
Command
gateway(config-if)# exit
gateway(config)# Ctrl-z
gateway#
Default Setting (Milliseconds)
100
5000
100
100
100
2000
0
OL-2031-02