Adding Secure Addresses - Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual

Managing the Catalyst 4224 Access Gateway Switch
Step 1
Step 2
Step 3
Step 4
Removing Dynamic Address Entries
Step 1
Step 2
Step 3
Step 4

Adding Secure Addresses

Catalyst 4224 Access Gateway Switch Software Configuration Guide
3-20
Beginning in privileged EXEC mode, follow these steps to configure the dynamic
address table aging time.
Task
Enter global configuration mode.
Enter the number of seconds that dynamic
addresses are to be retained in the address
table. You can enter a number from 10 to
1000000.
Return to privileged EXEC mode.
Verify your entry.
Beginning in privileged EXEC mode, follow these steps to remove a dynamic
address entry:
Task
Enter global configuration mode.
Enter the MAC address to be removed from
dynamic MAC address table.
Return to privileged EXEC mode.
Verify your entry.
You can remove all dynamic entries by using the clear mac-address-table
dynamic command in privileged EXEC mode.
The secure address table contains secure MAC addresses and their associated
ports and VLANs. A secure address is a manually entered unicast address that is
forwarded to only one port per VLAN. If you enter an address that is already
assigned to another port, the switch reassigns the secure address to the new port.
Chapter 3 Configuring Ethernet Switching
Command
configure terminal
mac-address-table aging-time
seconds
end
show mac-address-table
aging-time
Command
configure terminal
no mac-address-table dynamic
hw-addr
end
show mac-address-table
OL-2031-02