Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual page 63

Chapter 2 Configuring for the First Time
Table 2-2 Common Command Modes (continued)
Command Mode
Global configuration
Interface
configuration
Dial-peer
configuration
Timesaver
OL-2031-02
Access Method
From the privileged EXEC
mode, enter the configure
terminal command.
From the global
configuration mode, enter
the interface type number
command, such as
FastEthernet int 0/0.
From the global
configuration mode, enter
the dial-peer voice
command, such as
dial-peer voice 1
pots/voip.
Each command mode restricts you to a subset of commands. If you are having
trouble entering a command, check the prompt and enter the question mark (?) for
a list of available commands. You might be in the wrong command mode or using
the wrong syntax.
Catalyst 4224 Access Gateway Switch Software Configuration Guide
Gateway Prompt
Displayed
hostname
(config)#
The default is
router (config)#
hostname
(config-if)#
The default is
router (config-if)#
hostname
(config-
dial-peer)
The default is
router
(config-dial-peer)#
Using the Cisco IOS CLI
Exit Method
To exit to privileged EXEC
mode, use the exit or end
command, or press Ctrl-Z.
To exit to global
configuration mode, use
the exit command.
To exit directly to
privileged EXEC mode,
press Ctrl-Z.
To exit to global
configuration mode, use
the exit command.
To exit directly to
privileged EXEC mode,
press Ctrl-Z.
2-7