Configuring The Voice Interfaces; Configuring Voice Interfaces - Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual

Configuring Voice Interfaces

OL-2031-02

Configuring the Voice Interfaces

This section explains how to configure Voice-over-IP (VoIP) routing on the
supported interface cards of your Catalyst 4224 Access Gateway Switch. (You
need to perform the software configuration only for the cards that you have
installed.) To configure a voice interface, you must use configuration mode. In
this mode, you enter Cisco IOS command-line interface (CLI) commands at the
Gateway prompt.
This section includes the following topics:
Configuring Voice Interfaces, page 5-1
•
• MGCP Configuration, page 5-3
H.323 Gateway Configuration, page 5-16
•
Configuring T1-CAS Analog Emulation (H.323), page 5-19
•
ISDN BRI Configuration (H.323), page 5-24
•
T1/E1 Configuration (H.323), page 5-31
•
E&M Trunk Line Configuration (H.323), page 5-35
•
Use a voice interface card (VIC) for a voice connection. For information about
installing these components in a Catalyst 4224, refer to the Cisco Catalyst 4224
Access Gateway Switch Hardware Installation Guide. For an explanation about
how these components work and how they are identified, see the
Configuration" section on page
Catalyst 4224 Access Gateway Switch Software Configuration Guide
C H A P T E R
2-1.
5
"First-Time
5-1