Removing An Ip Address; Specifying A Domain Name And Configuring The Dns - Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual

Chapter 3 Configuring Ethernet Switching

Removing an IP Address

Note
Step 1
Step 2
Step 3
Step 4
Caution

Specifying a Domain Name and Configuring the DNS

OL-2031-02
Use the following procedure to remove IP information from a switch.
Using the no ip address command in configuration mode disables the IP protocol
stack and removes the IP information. Cluster members without IP addresses rely
on the IP protocol stack being enabled.
Beginning in privileged EXEC mode, follow these steps to remove an IP address:
Task
Enter interface configuration mode, and
enter the VLAN to which the IP
information is assigned.
VLAN 1 is the management VLAN, but you
can configure any VLAN from IDs 1 to
1001.
Remove the IP address and subnet mask.
Return to privileged EXEC mode.
Verify that the information was removed by
displaying the running configuration.
If you are removing the IP address through a Telnet session, your connection to
the switch will be lost.
Each unique IP address can have an associated host name. Cisco IOS software
maintains a cache of host name-to-address mappings for use by the EXEC mode
commands connect, telnet, ping, and related Telnet support operations. This
cache speeds the process of converting names to addresses.
Catalyst 4224 Access Gateway Switch Software Configuration Guide
Managing the Catalyst 4224 Access Gateway Switch
Command
interface vlan 1
no ip address
end
show running-config
3-13