Where To Go Next; H.323 Gateway Configuration - Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual

H.323 Gateway Configuration

Where to Go Next

H.323 Gateway Configuration
Catalyst 4224 Access Gateway Switch Software Configuration Guide
5-16
At this point, make sure that Cisco CallManager is properly configured to
provision the voice gateway and to configure MGCP endpoints or H.323 route
patterns as required. Refer to the documentation and online help provided with
Cisco CallManager. Refer to the Cisco IOS software configuration guide and
command reference publications for more advanced configuration topics. For
troubleshooting information, refer to the system error messages and debug
command reference publications.
Access these publications on the Documentation CD-ROM that came with your
gateway, or on the World Wide Web from the Cisco home page.
Compared to Media Gateway Control Protocol (MGCP), H.323 requires more
configuration on a gateway because the gateway must maintain the dial plan and
route pattern. The gateway must have enough information to direct calls to the
correct end point, which must be an H.323-capable device.
When using H.323, ensure that you configure Cisco CallManager correctly to
provision the Catalyst 4224 as an H.323 gateway, with route patterns configured
to route calls to a Catalyst 4224.
To provision the gateway using Cisco CallManager Administration, select the
Add a New Gateway option from Device > Gateway. Assign the Gateway Type
as H.323 Gateway, and the Device Protocol as H.225.
To configure a route pattern using CCM Administrator, select Route Plan >
Route Pattern and enter the route pattern. Then, select Cisco Catalyst 4224
gateway from a drop-down list, click the Route this option button for the Route
Option, and check the Provide Outside Dial Tone box for Offnet (the default is
OnNet).
Chapter 5 Configuring the Voice Interfaces
OL-2031-02