Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual page 87

Chapter 3 Configuring Ethernet Switching
Removing Static Addresses
Step 1
Step 2
Step 3
Step 4
OL-2031-02
Beginning in privileged EXEC mode, follow these steps to remove a static
address:
Task
Enter global configuration mode.
Enter the static MAC address, the interface,
and the VLAN ID of the port to be removed
Return to privileged EXEC mode.
Verify your entry.
You can remove all secure addresses by using the clear mac-address-table static
command in privileged EXEC mode.
Catalyst 4224 Access Gateway Switch Software Configuration Guide
Managing the Catalyst 4224 Access Gateway Switch
Command
configure terminal
no mac-address-table static
hw-addr [interface] interface
[vlan] vlan-id
end
show mac-address-table static
3-23