ISDN BRI Configuration (H.323)
ISDN BRI Configuration (H.323)
Step 1
Catalyst 4224 Access Gateway Switch Software Configuration Guide
5-24
calls to and from the PBX to which the gateway is connected. The commands
required to make these changes are shown below (all the extensions on the PBX
begin with the prefix 625):
c4224(config-controller)# dso-group 0 timeslots 1 type
e&m-immediate-start
c4224(config)# dial-peer voice 1 pots
c4224(config-dial-peer)# port 1/0:0
c4224(config-dial-peer)# destination-pattern 625....
To configure an ISDN BRI interface, perform the following steps. After
completing these steps, configure the route pattern and dial plan and save your
configuration, as described in
page
5-16.
Enter an ISDN switch type by entering the following command in global
configuration mode:
c4224(config)# isdn switch-type switch-type
See
Table 5-3
for a list of ISDN switch types.
Note
Switch types configured in interface configuration mode override this
setting for the configured interface.
Chapter 5
"H.323 Gateway Configuration" section on
Configuring the Voice Interfaces
OL-2031-02