Table of Contents
Advertisement
T1/E1 Configuration (H.323)
Note
E1/PRI Configuration Example
Catalyst 4224 Access Gateway Switch Software Configuration Guide
5-34
Configure each channel group as a virtual serial interface.
b.
c4224(config-controller)# interface serial 1/0:31
Specify the E1 interface, unit number, and channel group to modify, as in the
c.
following example:
interface Serial1/0:23
no ip address
no logging event link-status
isdn switch-type primary-5ess
isdn incoming-voice voice
no cdp enable
After completing these steps, configure the route pattern and dial plan and
save your configuration, as described in
section on page
5-16.
isdn switch-type primary-5ess
isdn voice-call-failure 0
controller E1 1/0
framing esf
linecode b8zs
pri-group timeslots 1-31
interface Serial 1/0:15
no ip address
no logging event link-status
isdn switch-type primary-5ess
isdn incoming-voice voice
no cdp enable
Chapter 5
Configuring the Voice Interfaces
"H.323 Gateway Configuration"
OL-2031-02
Advertisement
Table of Contents
Troubleshooting
