Processor Terminator Modules; Removal And Replacement Procedures - Compaq 5500R - ProLiant - 256 MB RAM Maintenance And Service Manual

Processor Terminator Modules

Processor Terminator boards must be installed in processor slots that are not in use; they are
removed when installing additional processors.
NOTE: Seat processor terminator boards securely in processor slots that are not in use.
To remove a processor terminator board:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the side access panel. See "Side Access Panel" earlier in this chapter.
3. Loosen the captive screw .
4. Pull up the ejector levers .
5. Lift the terminator board out of the connector socket.
Figure 2-23. Removing the processor terminator board
Reverse steps 1 through 5 to replace a processor terminator board.
2
1
For use with Pentium II and Pentium III Xeon processor-based servers only

Removal and Replacement Procedures 2-29

2
3