U-Channel Access Panel - Compaq 5500R - ProLiant - 256 MB RAM Maintenance And Service Manual
For use with pentium ii xeon and pentium iii xeon processor-based servers only
Hide thumbs
Also See for 5500R - ProLiant - 256 MB RAM:
- Setup and installation manual (169 pages) ,
- Integration notes (29 pages) ,
- Configuration manual (9 pages)
Table of Contents
Advertisement
U-Channel Access Panel
To remove the U-channel access panel:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the drive cage assembly. See "Drive Cage Assembly" later in this chapter.
3. Slide the U-channel access panel forward, then pull it away from the chassis.
Figure 2-6. Removing the U-channel access panel
Reverse steps 1 through 3 to replace the U-channel access panel.
For use with Pentium II and Pentium III Xeon processor-based servers only
Removal and Replacement Procedures 2-11
Advertisement
Table of Contents
