Compaq 5500R - ProLiant - 256 MB RAM Maintenance And Service Manual page 67

Table 3-2
POST Error Messages
continued
Audible Beeps
Error Code L=Long S=Short
175-
Configuration/Slot
Mismatch Device
Found
177-Configuration
Not Complete
178-Processor
Configuration Invalid
180-Log Reinitialized
201-Memory Error
203-Memory
Address Error
207-Invalid Memory
Configuration -
Check DIMM [SIMM]
Installation
208-Invalid Memory
Speed - Check DIMM
[SIMM] Installation
209-Memory
Detection Failure.
Check Memory
Installation
211-Cache Switch
Set Incorrectly
212-System
Processor
Failed/Mapped out
214-DC-DC
Converter Failed
214-Processor PPM
Failed Module X
215-Processor Power
Module has lost
Redundancy in
Socket x
215-Nonfunctioning
Voltage Regulator
Module for
Processors
For use with Pentium II and Pentium III Xeon processor-based servers only
Probable Source of Problem
None EISA or PCI board added,
configuration not updated.
None Incomplete System
Configuration.
None Processor type or step does not
match configuration memory.
None N/A
None RAM failure.
None RAM failure.
None Memory module installed
incorrectly.
1L, 1S The speed of the memory is too
slow, where: xx00 = expansion
board SIMMs are too slow, or
00yy = system board SIMMs are
too slow. xx and yy have
corresponding bit set.
1L, 1S Unable to size memory.
None Switch not set properly during
installation or upgrade.
1S Processor in slot x failed.
None PowerSafe Module (DC-DC
Converter) failed.
None Indicated PPM (DC-DC Converter)
failed.
None PPM (DC-DC Converter) has lost
redundancy.
None PPM (DC-DC Converter) has
failed or lost redundancy.
Diagnostic Tools 3-9
Recommended Action
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
N/A
Run Diagnostics. Replace failed
assembly as indicated.
Run Diagnostics. Replace failed
assembly as indicated.
Verify placement of memory
modules.
The speed of the memory
modules must be 60 ns. Verify
the speed of the memory
modules installed and replace.
Check DIMM installation. If error
persists, replace DIMM.
Verify switch settings.
Run Diagnostics and replace
failed processor.
Run Diagnostics. Replace failed
assembly as indicated.
Replace failed assembly as
indicated.
Run Diagnostics. Replace failed
assembly as indicated.
Run Diagnostics. Replace failed
assembly as indicated.
continued