Features; Processor And Redundant Processor Power Modules; System Memory - Compaq ProLiant 6000 Series Setup And Installation Manual

1-2 Introduction

Features

The following features are available on Compaq ProLiant 6000 models.
Processor and Redundant
Processor Power Modules
Supports up to four processors and four redundant processor power
modules
Evaporator plate and water-cooled heat pipes attached to the processor
One redundant processor power module per processor

System Memory

ECC (Error Checking and Correcting Memory) with single-bit error
correction and detection down to a single DIMM and multi-bit error
detection down to the memory bank
Expandable to 8 GB (32 x 256-MB DIMMs)
Supports up to eight memory banks with each bank consisting of four
DIMMs. One bank is installed or removed at a time. Each DIMM of a
given bank must be the same size, type, and speed.
Supports EDO 60ns or faster DIMMs
Performance enhancement by configuring your memory to take
advantage of address bit permuting
IMPORTANT: You cannot mix Pentium III Xeon processors in a server that
has Pentium II Xeon processors.
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only