64-Bit Dual Channel Wide Ultra2 Scsi Adapter - Compaq 5500R - ProLiant - 256 MB RAM Maintenance And Service Manual

2-36 Compaq ProLiant 5500 and 5500R Maintenance and Service Guide

64-bit Dual Channel Wide Ultra2 SCSI Adapter

Compaq ProLiant 5500 and 5500R Ultra2 Model Servers contain seven I/O expansion slots:
Six dedicated PCI slots: one occupied by a preinstalled Network Interface Controller and
I
one occupied by a 64-bit Dual Channel Wide Ultra2 SCSI Adapter
One shared PCI/ISA slot
I
To remove a 64-bit Dual Channel Wide Ultra2 SCSI Adapter:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the side access panel. See "Side Access Panel" earlier in this chapter.
3. Disconnect any cables from the controller.
4. Open the slot release lever by pressing on its ribbed area .
5. Gripping each end of the controller, gently remove it without disturbing other installed
boards .
Figure 2-29. Removing the 64-bit Dual Channel Wide Ultra2 SCSI Adapter
Reverse steps 1 through 5 to replace the 64-bit Dual Channel Wide Ultra2 SCSI Adapter.
1
2
For use with Pentium II and Pentium III Xeon processor-based servers only