Network Interface Controller (Nic) - Compaq 5500R - ProLiant - 256 MB RAM Maintenance And Service Manual
For use with pentium ii xeon and pentium iii xeon processor-based servers only
Hide thumbs
Also See for 5500R - ProLiant - 256 MB RAM:
- Setup and installation manual (169 pages) ,
- Integration notes (29 pages) ,
- Configuration manual (9 pages)
Table of Contents
Advertisement
Network Interface Controller (NIC)
To remove a NIC:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the side access panel. See "Side Access Panel" earlier in this chapter.
3. Disconnect any cables from the controller.
4. Open the slot release lever by pressing on its ribbed area .
5. Gripping each end of the controller, gently remove it without disturbing other installed
boards .
Figure 2-30. Removing the NIC
Reverse steps 1 through 5 to replace the NIC.
2
1
For use with Pentium II and Pentium III Xeon processor-based servers only
Removal and Replacement Procedures 2-37
Advertisement
Table of Contents
