External Replacement Battery - Compaq 5500R - ProLiant - 256 MB RAM Maintenance And Service Manual

External Replacement Battery

To install the external replacement battery:
CAUTION: Do not remove the lithium battery from the peripheral board or permanent damage
may occur. If the battery fails, use the external replacement battery.
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the side access panel. See "Side Access Panel" earlier in this chapter.
3. Remove the jumper from location E3 on the peripheral board .
4. Connect the battery cable to the E6 battery header on the peripheral board .
5. Remove the adhesive backing from the hook-and-loop fastener strip. Place the battery and
the hook-and-loop fastener strip as indicated in the following illustration .
Figure 2-36. Installing the external replacement battery
6. Place the label included with your battery kit on the back of your server above the power
connector.
WARNING: To reduce the risk of electric shock or damage to the equipment:
I
I
I
2
1
Do not disable the power cord grounding plug. The grounding plug is an important safety
feature.
Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all
times.
Disconnect power from the server or other product by unplugging the power cord from
either the electrical outlet or the server or other product.
For use with Pentium II and Pentium III Xeon processor-based servers only
Removal and Replacement Procedures 2-43
3