Compaq 5500R - ProLiant - 256 MB RAM Maintenance And Service Manual page 72

3-14 Compaq ProLiant 5500 and 5500R Maintenance and Service Guide
Table 3-2
POST Error Messages
Error Code
1764-Slot x Drive Array - Capacity Expansion Process is temporarily disabled
(followed by one of the following):
Expansion will resume when Array Accelerator has been reattached.
I
Expansion will resume when Array Accelerator has been replaced.
I
Expansion will resume when Array Accelerator RAM allocation is successful.
I
Expansion will resume when Array Accelerator battery reaches full charge.
I
Expansion will resume when automatic data recovery has been completed.
I
1765-Slot x Drive Array Option ROM Appears to Conflict With an ISA Card. ISA
cards with 16-bit memory cannot be configured in memory range C0000 to DFFFF
along with the SMART-2/E 8-bit Option ROM due to EISA bus limitations. Please
remove or reconfigure your ISA card.
1766-Slot x Drive Array requires System ROM Upgrade. Run Systems ROMPaq
Utility.
1767-Slot x Drive Array Option ROM is Not Programmed Correctly or may Conflict
with the Memory Address Range of an ISA Card. Check the Memory Address
Configuration of installed ISA Card(s) or run Options ROMPaq Utility to attempt
SMART-2/E Option ROM Reprogramming.
1768-Slot x Drive
Array -Resuming
logical drive
expansion process.
1769-Slot x Drive
Array - Drive(s)
disabled due to
failure during
expand. Select F1 to
continue with logical
drives disabled.
Select F2 to accept
data loss and to re-
enable logical drives.
1771-Primary Disk
Port Address
Assignment Conflict
1772-Secondary
Disk Port Address
Assignment Conflict
continued
Audible Beeps
L=Long S=Short
None
None
None
None
For use with Pentium II and Pentium III Xeon processor-based servers only
Probable Source of Problem
SMART-2 Controller error.
SMART-2 Controller error.
Internal and external hard drive
controllers are both assigned to
the primary address.
Address Assignment Conflict.
Internal and external hard drive
controllers are both assigned to
the secondary address.
Recommended Action
Reattach or replace Array
Accelerator, wait until the Array
Accelerator batteries have
charged, or for Automatic Data
Recovery to complete, as
indicated.
Remove or reconfigure
conflicting ISA cards. Disable
"shared memory" on any ISA
network cards that may be
installed.
Run the latest Systems ROMPaq
Utility to upgrade your System
ROMs.
Remove or reconfigure
conflicting ISA cards, especially
any cards that are not
recognized by the System
Configuration Utility. Try
reprogramming the ROM on the
SMART-2/E Controller using the
latest Options ROMPaq
(version 2.29 or higher).
No action required. Appears
whenever a controller reset or
power cycle occurs while array
expansion is in progress.
Data has been lost while
expanding the array, therefore
the drives have been
temporarily disabled. Press F2
to accept the data loss and
re-enable the logical drives.
Restore data from backup.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
continued