2-26 Compaq ProLiant 5500 and 5500R Maintenance and Service Guide
Processor, Processor Power Module, and Terminator Board Locations
IMPORTANT: A processor power module must be installed in the slot next to each processor. Each
processor slot must either be populated by a processor or terminator board for proper bus termination.
Figure 2-20. Location of processor, processor power module, and terminator boards
Location of Processor, Processor Power Module, and Terminator Modules
Location
Description
Processor Power Module 4
Processor 4 or Terminator Module 4
Processor 3 or Terminator Module 3
Processor Power Module 3
Processor Power Module 2
Processor 2 or Terminator Module 2
Processor 1 or Terminator Module 1
Processor Power Module 1
For use with Pentium II and Pentium III Xeon processor-based servers only
1
2
3
4
5
6
7
8
Table 2-3