Compaq 5500R - ProLiant - 256 MB RAM Maintenance And Service Manual page 28
For use with pentium ii xeon and pentium iii xeon processor-based servers only
Hide thumbs
Also See for 5500R - ProLiant - 256 MB RAM:
- Setup and installation manual (169 pages) ,
- Integration notes (29 pages) ,
- Configuration manual (9 pages)
Table of Contents
Advertisement
To remove a front fan:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the side access panel. See "Side Access Panel" earlier in this chapter.
3. Disconnect the fan controller cable .
IMPORTANT: Fan cables and locations are numbered. Make sure each fan cable is connected to the
corresponding fan.
4. Push up the latch on the side of the fan .
5. Lift the fan straight out of the chassis .
1
2
Figure 2-8. Removing a front fan
Reverse steps 1 through 5 to replace a front fan.
For use with Pentium II and Pentium III Xeon processor-based servers only
Removal and Replacement Procedures 2-13
3
Advertisement
Table of Contents
