Memory Board - Compaq 5500R - ProLiant - 256 MB RAM Maintenance And Service Manual
For use with pentium ii xeon and pentium iii xeon processor-based servers only
Hide thumbs
Also See for 5500R - ProLiant - 256 MB RAM:
- Setup and installation manual (169 pages) ,
- Integration notes (29 pages) ,
- Configuration manual (9 pages)
Table of Contents
Advertisement
2-34 Compaq ProLiant 5500 and 5500R Maintenance and Service Guide
Memory Board
To remove the memory board:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the side access panel. See "Side Access Panel" earlier in this chapter.
3. Pull the locking levers outward on each end of the memory expansion board.
4. Pull the memory board from the system I/O board .
NOTE: The illustration below shows the server placed on its side. It is not necessary to place the server
on its side to remove the memory board.
Figure 2-27. Removing the memory board
Reverse steps 1 through 4 to replace the memory board.
1
For use with Pentium II and Pentium III Xeon processor-based servers only
2
1
Advertisement
Table of Contents
