Compaq 5500R - ProLiant - 256 MB RAM Maintenance And Service Manual page 71

Table 3-2
POST Error Messages
continued
Audible Beeps
Error Code L=Long S=Short
1726-Slot x Drive
Array – Array
Accelerator Memory
Size Change
Detected
1727-Slot x Drive
Array – New Logical
Drive(s) Attachment
Detected.
If more than 32
logical drives, this
message will be
followed by: Auto-
configuration failed:
Too many logical
drives.
1730-Fixed Disk 0
does not support
DMA Mode.
1731-Fixed Disk 1
does not support
DMA Mode.
1740-Fixed Disk 0
failed Set Block
Mode command
1741-Fixed Disk 1
failed Set Block
Mode command
1750-Fixed Disk 0
failed Identify
command
1751-Fixed Disk 1
failed Identify
command
1760-Fixed Disk 0
does not support
Block Mode
1761-Fixed Disk 1
does not support
Block Mode
For use with Pentium II and Pentium III Xeon processor-based servers only
Probable Source of Problem
None Configuration update.
None Additional drives.
None Hard drive error.
None Hard drive error.
None Hard drive error.
None Hard drive error.
None Hard drive error.
None Hard drive error.
None Hard drive error.
None Hard drive error.
Diagnostic Tools 3-13
Recommended Action
Indicates array accelerator
configuration has been updated
automatically due to
replacement of Array
Accelerator (or controller) with
one having different memory
size. Press F1 to resume.
This message indicates that the
controller has detected an
additional array of drives that
was attached when the power
was off. The logical drive
configuration information has
been updated to add the new
logical drives. The maximum
number of logical drives
supported is 32. Additional
logical drives will not be added
to the configuration. Press F1 to
resume.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
continued