Removable Media - Compaq 5500R - ProLiant - 256 MB RAM Maintenance And Service Manual
For use with pentium ii xeon and pentium iii xeon processor-based servers only
Hide thumbs
Also See for 5500R - ProLiant - 256 MB RAM:
- Setup and installation manual (169 pages) ,
- Integration notes (29 pages) ,
- Configuration manual (9 pages)
Table of Contents
Advertisement
Removable Media
To remove a drive from the removable media area:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the drive cage assembly. See "Drive Cage Assembly" earlier in this chapter.
3. Disconnect the power and signal cables from the removable media device.
4. Remove the four T-15 screws securing the removable media panel to the drive cage
assembly .
5. Pull the removable media panel away from the drive cage assembly.
6. Remove the four T-15 screws securing the drive to the drive cage assembly .
7. Pull the drive out the front of the drive cage assembly .
2
Figure 2-13. Removing the CD-ROM drive from the removable media area
Reverse steps 1 through 7 to replace a drive in the removable media area.
For use with Pentium II and Pentium III Xeon processor-based servers only
Removal and Replacement Procedures 2-19
2
3
1
Advertisement
Table of Contents
