Processor Removal - Compaq 5500R - ProLiant - 256 MB RAM Maintenance And Service Manual

Processor Removal

Compaq ProLiant 5500 and 5500R Servers support up to four processors, each with its own heat
sink. To remove a processor:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the side access panel. See "Side Access Panel" earlier in this chapter.
Figure 2-21. Removing the processor
3. Loosen the captive screw .
4. Pull up the ejector levers .
5. Lift the processor out of the connector socket .
Reverse steps 1 through 5 to replace the processor.
NOTE: If not replacing the processor, install a processor terminator module in its place.
2
For use with Pentium II and Pentium III Xeon processor-based servers only
Removal and Replacement Procedures 2-27
2
1
3