Drive Cage Assembly - Compaq 5500R - ProLiant - 256 MB RAM Maintenance And Service Manual
For use with pentium ii xeon and pentium iii xeon processor-based servers only
Hide thumbs
Also See for 5500R - ProLiant - 256 MB RAM:
- Setup and installation manual (169 pages) ,
- Integration notes (29 pages) ,
- Configuration manual (9 pages)
Table of Contents
Advertisement
2-16 Compaq ProLiant 5500 and 5500R Maintenance and Service Guide
Drive Cage Assembly
To remove the drive cage assembly:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the side access panel. See "Side Access Panel" earlier in this chapter.
3. Open the front bezel door (tower model only).
Figure 2-10. Removing the drive cage assembly
4. Loosen the two thumbscrews securing the drive cage to the front of the chassis .
5. Pull out the plunger mechanism securing the drive cage assembly to the chassis .
6. Pull the drive cage partially from the chassis to allow better access to cables.
7. Disconnect all cables.
8. Slide the drive cage assembly out the front of the chassis .
Reverse steps 1 through 8 to replace the drive cage assembly.
For use with Pentium II and Pentium III Xeon processor-based servers only
1
2
3
1
Advertisement
Table of Contents
