Compaq 5500R - ProLiant - 256 MB RAM Maintenance And Service Manual page 69

Table 3-2
POST Error Messages
continued
Audible Beeps
Error Code L=Long S=Short
601-Diskette
Controller Error
605-Diskette Drive
Type Error
1151-Com Port 1
Address Assignment
Conflict
1152-Com Port 2, 3,
or 4 Address
Assignment Conflict
1610-Temperature
violation detected.
Waiting for system to
cool
1611-Fan failure
detected
1611-I/O Fan (Fan X)
failure detected
1611-CPU Fan
(Fan X) failure
detected
1612-Primary power
supply failure
1613-Low System
Battery
1615-Power Supply
Failure, Power
Supply Unplugged, or
Power Supply Fan
Failure in Bay X
1617-Fan controller
not responding
1617-I/O Fan
controller not
responding
For use with Pentium II and Pentium III Xeon processor-based servers only
Probable Source of Problem
None Diskette controller circuitry
failure.
2S Mismatch in drive type.
2S Both external and internal serial
ports are assigned to COM1.
2S Both external and internal serial
ports are assigned to COM2,
COM3, or COM4.
2S Ambient system temperature too
hot.
2S Required fan either not installed
or not spinning.
2S I/O fan has failed.
2S CPU fan has failed.
2S Primary power supply has failed.
None Real-time clock system battery is
running low on power.
None A power supply has failed.
2S Fan controller failure.
2S I/O Fan controller failure.
Diagnostic Tools 3-11
Recommended Action
1. Make sure the diskette
drive cables are attached.
2. Replace the diskette drive
and/or cable.
3. Replace the system board.
Run the System Configuration
Utility to set diskette type
correctly.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Check fan in system
environment.
Check fans.
Replace the failed fan.
Replace the failed fan.
Replace power supply as soon
as possible.
Run Diagnostics. Replace failed
assembly as indicated.
Replace or check specified
power supply.
Check and replace failed
controller assembly.
Check and replace failed
controller assembly.
continued