Compaq 5500R - ProLiant - 256 MB RAM Maintenance And Service Manual page 70

3-12 Compaq ProLiant 5500 and 5500R Maintenance and Service Guide
Table 3-2
POST Error Messages
Error Code
1618-PCI slots
powered down.
Check PCI hot plug
enabler connectors.
1620-Locked SCSI
Bus Detected. Verify
SCSI bus cabling.
System halted.
1621-Current SCSI
bus cable
configuration is not
recommended
1703-SCSI cable
error detected.
Internal SCSI cable
not attached to
system board
connector. System
halted.
1720-Slot x Drive
Array – SMART Drive
Detects Imminent
Failure SCSI: Port y:
SCSI ID x
1724-Slot x Drive
Array – Physical
Drive Position
Change(s) Detected –
Logical drive
configuration has
automatically been
updated
continued
Audible Beeps
L=Long S=Short
None
None
None
None
None
None
For use with Pentium II and Pentium III Xeon processor-based servers only
Probable Source of Problem
PCI hot plug enabler is missing or
failed.
SCSI bus failure.
Improper SCSI bus cabling.
Incorrect cabling.
Pre-failure condition.
Drive change.
Recommended Action
Check and replace missing or
failed assembly.
Run Diagnostics. Replace failed
assembly as indicated.
Check documentation for proper
SCSI bus cabling.
Ensure that the integrated SCSI
controller has SCSI termination
attached.
Indicated drive has reported a
SMART predictive-failure
condition and may fail at some
time in the future. If drive is part
of a non-fault-tolerant
configuration, back up all data
before replacing drive and
restore all data afterwards. If
drive is part of a fault-tolerant
configuration, do not replace
drive unless all other drives in
array are on-line. Press F1 to
resume.
Indicates that logical drive
configuration has been updated
automatically following physical
drive position changes. Press F1
to resume.
continued