Wide Ultra2/Ultra3 Hard Drive Cage - Compaq DL580 - ProLiant - 1 GB RAM Maintenance And Service Manual

Wide Ultra2/Ultra3 Hard Drive Cage

NOTE: The ProLiant DL580 supports Wide Ultra3 SCSI technology.
To remove the Wide Ultra2/Ultra3 hard drive cage:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the three T-15 screws
the front of the chassis.
3. Remove the center wall. See "Center Wall" earlier in this chapter.
4. Pull the drive cage
drive cage up and away from the chassis.
Figure 2-27. Removing the Wide Ultra2/Ultra3 hard drive cage from the chassis
Reverse steps 1 through 4 to replace the Wide Ultra2/Ultra3 hard drive cage.
located on the front bezel that secure the drive cage to


toward the rear of the server to clear the two lower tabs, then lift the

2
Removal and Replacement Procedures 2-35
1
1
1