Configure Snmp - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Configuring the Switch
6. Select a port type by clicking in the Type field and selecting from the list.
7. To bind a device with a specific WWN or nickname to the port, click the Port
Binding check box to display a check mark. Then enter the WWN or configured
nickname for the device into the Bound WWN column. The device that you bind
to the port will have exclusive connection to that port.
Notes:
— If you have configured port binding and click Activate, a warning dialog box
displays if one or more of the nodes attached to a port does not match the
WWN or nickname configured in the Bound WWN column. This warning
box displays a list of all attached nodes that will be logged off if you continue.
If you click Continue, these nodes will log off and the port will only attach to
the device with the WWN or nickname configured in the Bound WWN
column.
— If you have configured port binding and click Activate, an error message may
display if the format for the WWN entered in the Bound WWN column is not
valid (not in xx.xx.xx.xx.xx.xx.xx.xx format) or if you enter a nickname that
has not been configured through the Product Manager.
8. Use the scroll bar on the right side of the Configure Ports dialog box table to
display additional ports that you want to configure.
9. Activate changes and close the dialog box by clicking Activate.
10. If you are finished configuring the switch, back up the configuration data. For
more information, refer to
page 3-29.

Configure SNMP

Use the procedures in this section to:
• Configure the SNMP agent that runs on the switch and implements the following
MIBs:
— MIB-II
— Fabric Element MIB
— Fibre Alliance (FCMGMT) MIB
— Switch private MIB
3–12
Backing Up and Restoring Configuration Data on
edge switch 2/24 product manager user guide