Configure Date And Time; Procedure - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

5. Click Activate to activate the new feature key.
An IPL will occur, during which the Ethernet connection between the HAFM
server and switch is momentarily interrupted.
NOTE: If you click Activate, all current features will be replaced with new features. That is, if
there are features shown in the current list that are not shown in the new list, then those features
will be removed from the switch.
6. Set the switch back online.
7. When you are finished configuring the switch, you can back up the configuration
data. For more information, refer to
Data on page

Configure Date and Time

Use the procedures in this section to display and change the date and time set on the
switch. You must set the current date and time on the switch using this dialog box so
the correct time stamps display in the Event Log, Audit Log, Hardware Log, Link
Incident Log, and Threshold Alerts Log.

Procedure

Set the switch date and time using the following steps:
1. Select Date/Time from the Configure menu on the menu bar.
The Configure Date and Time dialog box displays.
If the Periodic Date/Time Synchronization check box in the Configure Date
and Time dialog box is selected, the HAFM server periodically synchronizes the
switch time to the HAFM server, and daylight savings time automatically updates.
When the Periodic Date/Time Synchronization option is selected, the Date and
Time fields are disabled (grayed out).
If the Periodic Date/Time Synchronization check box is not selected, you can
set the HAFM server date and time manually.
edge switch 2/24 product manager user guide
3-29.
Backing Up and Restoring Configuration
Configuring the Switch
3–17