HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 162

Product Manager Messages
Table A–1: StorageWorks Edge Switch 2/24 Product Manager Messages (Continued)
Message
Port cannot swap to itself.
Port diagnostics cannot be
performed on an inactive
port.
Port speeds cannot be
configured at a higher rate
than the director/switch
speed.
Product Manager error
<number>.
Product Manager instance is
currently open.
R_A_TOV must be greater
than E_D_TOV.
Resource is unavailable.
SANtegrity Feature not
installed. Please contact
your sales representative.
Send firmware failed.
SNMP trap address not
defined.
A–12
Description
Port addresses entered in
the Swap Ports dialog box
are the same.
This displays when port
diagnostics is run on a port
in an inactive state.
This displays when you
configure a port to 2 GB/sec
and the switch speed is set
to 1 Gb/sec.
The switch Product
Manager encountered an
internal error and cannot
continue.
A Product Manager window
is currently open.
R_A_TOV must be greater
than E_D_TOV.
The specified operation
cannot be performed
because the product is
unavailable.
The user selected Switch
Binding from the Configure
menu, but the optional
SANtegrity feature is not
installed.
Send firmware operation
has failed.
An SNMP trap address must
be defined if a community
name is defined.
edge switch 2/24 product manager user guide
Action
Make sure that address in
the first and second port
address fields are different.
Run the diagnostics on an
active port.
Set the port speed to 1
Gb/sec in the Configure
Ports dialog box.
Report the problem to
support personnel.
Informational message only.
Change one of the values so
that R_A_TOV is greater
than E_D_TOV.
Verify that the HAFM
server-to-product link is up.
If the link is up, the HAFM
server may be busy. Try the
operation again later.
Install the SANtegrity key
through the Configure
Feature Key dialog box
before using Switch Binding
features.
Retry the operation. If the
condition persists, contact
support personnel.
Define an SNMP address.