Procedure - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Using Maintenance Features
After resetting the configuration, you must reset the original address on the switch
through the maintenance port or the Embedded Web Server interface to maintain LAN
connections and communication with the service processor.

Procedure

1. Set the switch offline. For instructions, refer to
2. Select Reset Configuration from the Maintenance menu on the menu bar. The
following warning displays:
WARNING: This operation will reset all switch configuration data and
non-volatile settings to factory default values. All optional features will also be
disabled. The switch must be offline to continue.
NOTE: If you have enabled features that add additional port function since the switch was
shipped from the factory, these features will be disabled (factory default) when the configuration
is reset. Only those ports that were enabled at the factory will function. You will have to enable
the additional port function features again through the Configure Feature Key dialog box.
Factory-default values may vary, depending on the firmware release installed in your
switch. For a list of values, refer to the hp StorageWorks edge switch 2/24 service
manual.
5–8
Set Online State on page
edge switch 2/24 product manager user guide
5-3.