HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 152

Product Manager Messages
Table A–1: StorageWorks Edge Switch 2/24 Product Manager Messages (Continued)
Message
Are you sure you want to
send firmware version?
Cannot disable Switch
Binding while Enterprise
Fabric Mode is active and
the switch is Online.
Cannot disable Insistent
Domain ID while Fabric
Binding is active.
Cannot enable beaconing
on a failed FRU.
Cannot enable beaconing
while the system error light
is on.
Cannot have spaces in field.
Cannot install firmware to a
switch with a failed CTP
card.
A–2
Description
Confirmation to add a
firmware version to the
firmware library. The
firmware library can hold
eight firmware versions.
User attempted to disable
switch binding through the
Switch Binding Change
State dialog box, but
Enterprise Fabric Mode is
enabled.
User attempted to disable
the Insistent Domain ID
parameter through the
Configure Switch
Parameters dialog box, but
Fabric Binding is enabled.
Occurs when selecting
Enable Beaconing option for
a failed FRU.
Beaconing cannot be
enabled while the system
error light is on.
Spaces are not allowed in
this field.
Firmware cannot be
installed on a switch with a
defective CTP card.
edge switch 2/24 product manager user guide
Action
Click Yes to confirm adding
the firmware version to the
firmware library, or no to
cancel the operation.
You must either disable
Enterprise Fabric Mode
using the Enterprise Fabric
Mode dialog box in the
HAFM application or set the
switch offline before you can
disable Switch Binding.
Disable Fabric Binding
through the Fabric Binding
dialog box before disabling
these parameters.
Replace FRU and enable
beaconing again or enable
beaconing on operating
FRU.
Select Clear System Error
Light from Product menu to
clear error light, then enable
beaconing.
Remove the spaces or
retype the field without
spaces.
Note that the CTP card is
not a FRU. If it fails, the
switch must be replaced.
After replacement, retry the
firmware install to the
switch.