Procedure; Configure Feature Key - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Procedure

To configure the Open Systems Management Server, use the following steps:
1. Select Management Server from the Configure menu on the menu bar.
The Configure Open Systems Management Server dialog box displays.
2. Enable the management server by clicking the Enable Management Server
check box to add a check mark. (To disable the management server, click the
check box again to remove the check mark.)
3. Click the check box in the Host Control Prohibited field to display a check mark
and prohibit a host management program from changing configuration and
connectivity parameters on the switch. In this case, the host program has
read-only access to configuration and connectivity parameters. Clicking the check
box when it contains a check mark removes the check mark and allows a host
program to change configuration and connectivity parameters on the switch.
4. Activate changes and close the dialog box by clicking Activate.
5. If you are finished configuring the switch, you can back up the configuration data.
For more information, refer to

Configure Feature Key

A feature key is a string of alphanumeric characters consisting of both uppercase and
lowercase. The following is an example of a feature key format:
XxXx-XXxX-xxXX-xX.
NOTE: The total number of characters may vary. The key is case-sensitive and must be
entered exactly, including the dashes.
The feature key, which is encoded with a switch's serial number, can only be
configured on the switch to which it is assigned.
To enable an optional feature on the switch, first set the switch offline, then enter the
feature key into the New Feature Key dialog box.
Display this dialog box by selecting Feature from the Configure menu on the menu
bar.
edge switch 2/24 product manager user guide
Backup and Restore Configuration on page
Configuring the Switch
5-6.
3–15