System Upgrade Using Isdn; Release Key; Backup; What Happens If The Upgrade Is Interrupted - TANDBERG MXP F8 Administrator's Manual

MXP
Contents Introduction

System upgrade using ISDN

The TANDBERG MXP systems can be software upgraded in three
different ways:
•
Using Web Interface
•
Using FTP
•
Using ISDN
Software File
Before starting the software upgrade of the TANDBERG MXP system,
please make sure to have the new Software File, (for instance
s050000F30.pkg).
Your TANDBERG Partner will provide this for you.

Release Key

Before starting the software upgrade of the TANDBERG MXP system,
please make sure to have the Release Key for this software available.
Your TANDBERG Partner will provide this for you.

Backup

All options and settings will automatically be stored when upgrading, so
no backup is necessary.

What happens If the upgrade is interrupted

If the system upgrade process is aborted before it's complete, the
system will work as normal with the original software.
D14033.06—AUGUST 2010
Getting started The menu structure The settings library

About far end ISDN system upgrade

NOTE! Far end software upgrade is only possible when in an ISDN
conference with one other far end endpoint. Both systems must be on
software version F3.0 or newer for this functionality.

The system upgrade procedure

To upgrade using the web interface, please do the following steps
1. Connect to the system that shall be upgraded using ISDN
2. Copy the new software file to a folder on your computer, for
instance c:\software.
3. Type the IP address of the TANDBERG MXP system that the
software upgrade is going to be done from (for instance 10.0.8.77)
in a standard browser, such as Internet Explorer 6.0. The web
interface of the codec will then be displayed.
4. Select the SYSTEM CONFIGURATION
then the sub-tab
Using the system Physical interfaces
tab on top of the page, and
FAR END UPGRADE.
Administrator Guide
Peripheral equipment Appendices Appendices
5. Enter the release key for the system to be upgraded in the 'Release
Key' field. If no release key is given, the Far End System will use
the previously stored release key if possible. This will work when
upgrading from a main release to a dot release.
6. Make sure the setting "Far End System Upgrade" is set to "On" at
the remote site. This setting can be found in the Settings/General/
Permissions menu.
7. Enter the password set at the far end for remote upgrade (default
password is "TANDBERG")
8. Press 'Install Software' .The system will now use about 90% of the
call capacity to transfer the software file across. During this time,
audio and video will be turned off.
9. Once the software has been transferred and verified at the far
end, you will get a new webpage with information that the upgrade
of the far end was successful. At the same time, a message box
will appear at the remote system asking if you want to reboot the
system to activate the new software.
10. To activate the new software. The ISDN connection needs to be
closed, and the TANDBERG MXP system must be rebooted. In the
menu on the system under 'Control Panel/System Information',
the installed software should now be displayed as the 'Software
Version'.
Contact us
320