Data Ports - TANDBERG MXP F8 Administrator's Manual

MXP
Contents Introduction
Codec 6000 MXP Interfaces and sockets, cont...

Data ports

PRECISION HD CAMERA CABLES
NOTE! The enclosed TANDBERG Camera
Cables must be used! Do not use other
camera cables as this might cause
problems with the transfer of video signals
from the Precision HD Camera.
Data Ports
Data port 1 Data port 2
WAVE II Camera
Pin Signal Direction Signal
name name
From Carrier
1 Carrier
DCE detect, CD
detect, CD
From Receive
2 Receive
DCE data, RXD
data, RXD
To DCE Transmit
3 Transmit
data, TXD
data, TXD
From 12 V / 1 A
4 Data
DCE
terminal
ready, DTR
Signal GND
5 Signal GND
From
6 Data set Data set
DCE
ready, DSR ready, DSR
To DCE
7 Ready to Ready to
send, RTS send, RTS
From
8 Clear to Clear to
DCE
send, CTS send, CTS
From
9 Ring Ring
DCE
indicator, RI indicator, RI
1) The TANDBERG main camera is normally connected to data
port 2 and pin No. 4 provides 12 V / 1 A to the main camera.
dc
Otherwise the pin-outs are the same for the two data ports.
D14033.06—AUGUST 2010
Getting started The menu structure
Data Ports
Data port 2
Precision HD Camera
Direction
Pin Signal Direction
name
From
To DCE
1 Video
DCE
LVDS+
From
From
2 Receive
DCE
DCE
data, RXD
To DCE
To DCE
3 Transmit
data, TXD
4 Power,
+12 V
5 Signal GND
To DCE
6 Video LVDS-
From
DCE
E1/T1 Interface
To DCE
PRI Pin- Crossover
out PRI cable
From
DCE Pin 1 RX+ 4
From
Pin 2 RX– 5
DCE
Pin 4 TX+ 1
Pin 5 TX– 2
The settings library Using the system
Data port 1 (upper) and Data port 2 (lower).
The Data ports are implemented as Digital Circuit
Terminating Equipment (DCE).
NOTE! The TANDBERG main camera is normally
connected to data port 2 and pin No. 4 provides
12 V / 1 A to the main camera. Otherwise the pin-
dc
outs are the same for the two data ports.
Ethernet USB
interface. For interface. For
future use. future use.
RJ-45 Connector pin-out
Physical interfaces Physical interfaces Peripheral equipment
9-pin D-SUB pin-out
External view of socket
1
6
Precision HD Camera
Pin-Out on 8 pin RJ
(shielded modular jack)
Signal Name Pin
Number
8
+12V (presence 2.8mA
current source when
connected in daisy
chain)
7
GND
6
TXD (out)
5
Video LVDS -
4
Video LVDS +
3
RXD (in)
2
GND
1
+12 V
This connector is used for the power,
video and control signals to the main
camera.
Administrator Guide
Appendices Contact us
5
9
Precision HD Camera
Pin-Out on 6 pin RJ
(modular jack)
Signal Name Pin
Number
6
GND
5
GND
4
RXD (in)
3
TXD (out)
2
Presence
(12 V in daisy
chain)
1
GND
This connector is used when
cascading cameras: Control
(out) signal and external camera
detection. NOTE: It does not
provide power for cascaded
camera.
263