Audio Output, Network And Data Port - TANDBERG MXP F8 Administrator's Manual

MXP
Contents Introduction
TANDBERG 550 MXP Interfaces and sockets, cont...

Audio output, Network and Data port

1 AUDIO OUTPUT
•
1 output (line level) via RCA connector providing audio from far
end in addition to dial tones. This output is used by the monitor.
Audio Output Connector Specification
Connector Label
Unbalanced
Signal type
Female RCA/phono, sleeve-
Copnnector (codec)
ground, centre-signal
680 ohms
Output Impedance
15.5 Vpp
Max output level when set to
maximum output level and
volume control set to max
1.2 Vpp
Max output level when set
to minimum output level and
volume control set to max
22.5 dB (16 steps of 1.5 dB)*
Range, menu adjustable
output gain
0 to 21 dB + mute (steps of 1.5
Volume control attenuation
dB)
(audio out 1)
* Additional attenuation is possible on room/loudspeaker audio output
using the volume control setting
D14033.06—AUGUST 2010
Getting started The menu structure
ETHERNET
•
1 x Ethernet (RJ-45 Jack) LAN interface (10/100 Mb) up to
768kbps
To connect the system to a LAN, use the Ethernet cable provided by
TANDBERG (or a standard Ethernet cable). If no LAN is available and
the codec is connected directly to a computer, use a crossover cable.
Audio Output(s)
Ethernet cable
1 ----------
2 ----------
3 ----------
6 ----------
Wiring diagram
standard cable
If no DHCP server is controlling the small LAN, which has been
created between the computer and the video system, then static
TCP/IP settings must be used.
When configuring a back-to-back connection between the PC and
the video system, make sure both static IP addresses exist on the
same subnet.
ISDN-BRI INTERFACE
•
3 x ISDN I.420 (RJ-45 Jack) Basic Rate Interface S/T (2B+D), 128
kbps per ISDN I/F
To connect the system to BRI, use the ISDN cable provided by
TANDBERG (or a standard BRI cable). The pinout of the S/T interface
is:
S/T Interface
BRI
Pin 3
Pin 4
Pin 5
Pin 6
The settings library Using the system
RJ-45 Connector pin-out
1 1 1
2 2 2
3 3 3
6 6 6
Wiring diagram
crossover cable
RJ-45 Connector pin-out
Pin out
TX+
RX+
RX–
TX–
Physical interfaces Physical interfaces Peripheral equipment
DATA PORT
The data port(s) are implemented as Data Communications
Equipment (DCE). The connectors used are female 9-pin D-subs.
Data Port - Pin Specification
Signal Name
Carrier detect, CD From DCE
Receive data, RXD From DCE
Transmit data, TXD To DCE
Data terminal ready, From DCE
DTR
Signal ground, GND -
Data set ready, DSR From DCE
Ready to send, RTS To DCE
Clear to send, CTS From DCE
Ring indicator, RI From DCE
Administrator Guide
Appendices Contact us
Direction Pin Number
1
2
3
4
5
6
7
8
9
291