Connecting The System To Isdn Using Nt1 Network Adapter; Placing The Nt1 Adapter; Connecting Cables; Configure The Video System - TANDBERG MXP F8 Administrator's Manual

MXP
Contents Introduction
Connecting the System to ISDN
using NT1 Network Adapter

Placing the NT1 Adapter

For convenience the NT1 adapters could be placed inside the video
systems cabinet.

Connecting Cables

•
Connect the first ISDN cable from ISDN1 on the video system
(codec) to the S-interface on your first NT1 network adapter.
•
Connect the other ISDN cables to the appropriate NT1 network
adapters.
•
Connect the U-interface of your NT1 adapter to the line provided
from your network provider.
ISDN Cables
•
Connect the shorter ISDN cable (RJ45 connectors) delivered with
the NT1 between the video system (codec) and the NT1 adapter.
•
Connect the longer ISDN cable between the NT1 and the connector
(RJ45) at the wall socket.
D14033.06—AUGUST 2010
Getting started The menu structure The settings library

Configure the Video System

To configure the video system go to Control Panel > Network > ISDN/
External/Leased E1/T1 and:
•
Set Network Type to
•
Go to ISDN-BRI Settings and select
•
Go to LINE 1
•
Enable Line 1
•
Enter ISDN Line Numbers (+ SPIDs if required).
•
Configure the other lines to be used.
Some software versions do not support 6 ISDN lines, therefore
some of the Line # Setup entries may be grayed out.
•
Disable unused lines.
•
Check if you need to configure the
Using the system Using the system Physical interfaces
ISDN-BRI
ISDN SWITCH TYPE
SETUP:
ADVANCED ISDN SETTINGS.
Administrator Guide
Peripheral equipment Appendices

Setting up a call

•
Go to the CALL MENU and select MAKE A CALL
•
In the Call Menu, open DEFAULT CALL SETTINGS
•
Set NET to ISDN
•
To use these settings for this call only, select the
To save the settings as your new Default Call Settings select
DEFAULT before pressing the OK button.
•
Go on with your call and enter the number to be dialed.
Contact us
OK button.
SET AS
247