TANDBERG MXP F8 Administrator's Manual page 213

MXP
Contents Introduction
MENU ADDRESS SETTINGS DESCRIPTION
Control Panel > CALL MANAGER EXTENSION
Network > If Call Manager was enabled in the
LAN Settings > Example: 524036
H.323 Settings >
CALL MANAGER SETTINGS
CALL MANAGER IP
Control Panel >
If Call Manager was enabled in the
Network >
Example: 10.0.0.30
LAN Settings >
H.323 Settings >
CALL MANAGER SETTINGS
Control Panel > NAT
NAT support in the videoconferencing system enables proper exchange of audio/video data when connected to
Network >
an external videoconferencing system (when the IP traffic goes through a NAT router).
LAN Settings >
OFF: The system will signal the real IP Address.
H.323 Settings >
ON: The system will signal the configured "NAT Address" in place of its own IP-address within Q.931 and
ADVANCED H.323 SETTINGS
H.245. When NAT is On, the NAT Server Address will be shown in the startup-menu as: My IP Address:
10.0.2.1
AUTO: The system will try to determine if the "NAT Address" or the real IP-address should be used within signaling. This is
done to make it possible to place calls to endpoints on the LAN as well as endpoints on the WAN.
Control Panel > NAT ADDRESS
This must be the external/global IP-address to the router with NAT support. Packets sent to the router will
Network >
then be routed to the system. In the router, the following ports must be routed to the system's IP-address:
LAN Settings >
•
Port 1720
H.323 Settings >
•
Port 5555-5574
ADVANCED H.323 SETTINGS
•
Port 2326-2485
Control Panel > RSVP
Network > AUTO: Resource Reservation Protocol enables the system to request the optimum amount of bandwidth for
the duration of an IP video conference.
LAN Settings >
OFF: Resource Reservation Protocol is switched Off.
H.323 Settings >
ADVANCED H.323 SETTINGS
D14033.06—AUGUST 2010
Getting started The menu structure The settings library The settings library
H.323 Call Setup, you may enter a call manager extention in this field.
H.323 Call Setup, enter the IP Address to the Call Manager in this field.
Using the system Physical interfaces Peripheral equipment
INFORMATION
NOTE! The Advanced H.323 Settings only have effect if they are
supported by your IP infrastructure.
The Advanced H.323 Settings only have effect if they are
NOTE!
supported by your IP infrastructure.
NOTE! The Advanced H.323 Settings only have effect if they are
supported by your IP infrastructure.
Administrator Guide
Appendices Contact us
PRODUCT
All MXP
systems
All MXP
systems
All MXP
systems
All MXP
systems
213