TANDBERG 6000 MXP Quick Start Manual
Hide thumbs
Also See for 6000 MXP:
- User manual (341 pages) ,
- Administrator's manual (375 pages) ,
- Installation manual (6 pages)
Advertisement
Quick Links
Tandberg 6000 MXP
C
6000 MXP I
ONNECTING THE
1. Connect Line Output D of the Vortex Device to the 6000 MXP codec mixer Input 4 as
shown below using the attached RCA cable.
2. Connect Line Input C of the Vortex Device to the Main line level Output 1 of the 6000
MXP codec as shown below using the other attached RCA cable.
3. Connect Line Output 1 to the Audio or Speaker input of the amplifier or video display to
hear the far end audio using the final attached cable.
O
NPUTS AND
UTPUTS
See next page for Tandberg settings.
Advertisement
Related Manuals for TANDBERG 6000 MXP
Summary of Contents for TANDBERG 6000 MXP
- Page 1 NPUTS AND UTPUTS 1. Connect Line Output D of the Vortex Device to the 6000 MXP codec mixer Input 4 as shown below using the attached RCA cable. 2. Connect Line Input C of the Vortex Device to the Main line level Output 1 of the 6000 MXP codec as shown below using the other attached RCA cable.
- Page 2 To configure the Tandberg 6000 MVX system to use Revolabs DSP Package microphones: Go to Audio Settings. Set Input 4 and Output 1 to ON. Disable Echo Canceller. Adjust the audio Input Type Level if necessary. Speak into the Revolabs microphones that are connected to the audio line inputs.