TANDBERG MXP F8 Administrator's Manual page 202

MXP
Contents Introduction
MENU ADDRESS SETTINGS DESCRIPTION
Control Panel > ISDN SWITCH TYPE
Network > Select the type of ISDN network connected to your unit.
ISDN > or ISDN, External, Leased Note that 1TR6 should only be used if you are operating the system behind a PABX.
E1/T1 >
ISDN-BRI SETTINGS
Control Panel > AUTO BRI CONFIG
Network > The Auto-BRI Config setting is only applicable after the ISDN Switch Type is set to National ISDN and the
change has been saved.
ISDN > or ISDN, External, Leased
E1/T1 > ON: When set to On, the system retrieves SPID (Service Profile Identifier) values automatically from the
network. Not supported by all National ISDN networks.
ISDN-BRI SETTINGS
OFF: When set to Off the SPID is to be set manually.
LINE ENABLE
Control Panel >
Select Line Setup for the ISDN-BRI Line you want to configure. Enable the active lines and disable the
Network >
unused lines. Note that Line 1 should always be enabled.
ISDN > or
ON: When set to On the ISDN-BRI line is enabled. Line 1 should always be enabled.
ISDN, External, Leased E1/T1 >
OFF: When set to Off the ISDN-BRI line is disabled. Unused ISDN-BRI lines must be disabled.
ISDN-BRI Settings
LINE 1-6 SETUP
Control Panel > NUMBER 1, NUMBER 2
Select Line # Setup for the ISDN-BRI Line you want to configure. Enable the active lines and disable the
Network >
unused lines.
ISDN > or
Enter the numbers associated with your ISDN-BRI lines.
ISDN, External, Leased E1/T1 >
Most BRI's with SPID's are area code and number at the end, like so: 70312345670101
ISDN-BRI Settings
LINE 1-6 SETUP
Control Panel > SPID1, SPID2
If your ISDN-BRI Switch Type is
Network >
Profile IDentifier) numbers associated with your ISDN-BRI numbers.
ISDN > or
If you have received two different SPID numbers for each ISDN-BRI line from your network provider, you must
ISDN, External, Leased E1/T1 >
enter both numbers.
ISDN-BRI Settings
LINE 1-6 SETUP
D14033.06—AUGUST 2010
Getting started The menu structure The settings library The settings library
NATIONAL ISDN or AT&T CUSTOM
Using the system Physical interfaces
ISDN, they might require SPID (Service
Peripheral equipment Appendices
INFORMATION
Some software versions do not support 6 ISDN-BRI lines. If so,
some of the Line Setup entries may be grayed out.
Administrator Guide
Contact us
PRODUCT
All MXP
systems
with ISDN-
BRI
All MXP
systems
with ISDN-
BRI
All MXP
systems
with ISDN-
BRI
All MXP
systems
with ISDN-
BRI
All MXP
systems
with ISDN-
BRI
202