TANDBERG MXP F8 Administrator's Manual page 217

MXP
Contents Introduction
MENU ADDRESS SETTINGS DESCRIPTION
Control Panel > SIP AUTHENTICATION FOR TURN
Network > If your TURN user credentials are the same as for the SIP authentication (Network > LAN Settings > SIP
Settings > Authentication), you can check mark this box to use the same user name and password.
LAN Settings >
If your TURN user credentials are different you must enter your TURN user name and TURN password.
SIP Settings
USER NAME: This is the user name part of the credentials used to authenticate toward the TURN Server.
SIP NAT TRAVERSAL
PASSWORD: This is the password part of the credentials used to authenticate toward the TURN Server.
Control Panel > SSID
Network > SSID* - Service Set Identification. Defines a local network ID for this wireless region. The SSID must be the
same for all endpoints and the access point. An endpoint will find the access point if the SSID is correct,
LAN Settings >
however if the encryption key is faulty it will not transmit any data.
WIRELESS LAN SETTINGS
Example: "WLANNETWORK"
NOTE! The PC card/PCMCIA-card used must comply with the relevant regulations for such cards in the
country where it is used. The unit must be supplied by power supply (AC-DC adaptor) powerbox SPN-270-
12, which complies with the requirements for limited power source according to IEC/EN 60950.
COMMUNITY
Control Panel >
Community* (optional) can be used when connecting to an access point where the SSID is the same.
Network >
LAN Settings > The Community name can be up to 32 characters long.
WIRELESS LAN SETTINGS Example: "Unit2"
Control Panel > WLAN MODE
Defines the WLAN Mode*. Make sure the corresponding settings are programmed into the access point.
Network >
ADHOC: Used when not communicating with an access point.
LAN Settings >
WIRELESS LAN SETTINGS MANAGED: Used when communication is made through an access point.
Control Panel > ENCRYPTION
Network > Select Encryption if you want to use WEP encryption on your Wireless LAN connection. Increased encryption
level will decrease performance.
LAN Settings >
NOTE: An endpoint will find the access point if the SSID is correct, however if the encryption key is faulty it
Wireless LAN Settings >
will not transmit any data.
ENCRYPTION
OFF: Select Off to disable WEP encryption on your Wireless LAN connection
64 BIT: Select 64 bit to enable 64 bit WEP encryption on your Wireless LAN connection
128 BIT: Select 128 bit to enable 128 bit WEP encryption on your Wireless LAN connection
D14033.06—AUGUST 2010
Getting started The menu structure The settings library The settings library Using the system Physical interfaces Peripheral equipment
INFORMATION
Read more about Wireless Network Adapters in the section
Using the system.
* The wireless card option is not supported in the current version of the
Compass/Utility MXP.
* The wireless card option is not supported in the current version of the
Compass/Utility MXP.
* The wireless card option is not supported in the current version of the
Compass/Utility MXP.
Administrator Guide
Appendices Contact us
PRODUCT
All MXP
systems
with WLAN
All MXP
systems
with WLAN
All MXP
systems
with WLAN
All MXP
systems
with WLAN
217