TANDBERG MXP F8 Administrator's Manual page 212

MXP
Contents Introduction
MENU ADDRESS SETTINGS DESCRIPTION
Control Panel > H.323 ID
Network > When using a Gatekeeper, the system will send a message to the Gatekeeper containing both the E.164 Alias
and the H.323 ID of the system.
LAN Settings >
The H.323 ID of the system may be specified here. The System Name is used if no H.323 ID is entered.
H.323 Settings >
Example: "Alice Wonderland", "System 01"
GATEKEEPER SETTINGS
DISCOVERY
Control Panel >
AUTO: The system will automatically try to register to any available Gatekeeper. If a Gatekeeper responds
Network >
to the request sent from the codec within 30 seconds this specific Gatekeeper will be used. This
LAN Settings >
requires auto discovery on the Gatekeeper as well. If no Gatekeeper responds, the system will not use a
H.323 Settings >
Gatekeeper for making H.323 calls and hence an IP-address must be specified manually.
GATEKEEPER SETTINGS
MANUAL: The system will use a specific Gatekeeper identified by the Gatekeeper's IP-address.
IP ADDRESS
Control Panel >
Defines the Gatekeeper IP-address.
Network >
LAN Settings > If your system is part of a TANDBERG Expressway™ firewall traversal solution and is placed outside the
firewall, you should register the IP address of your Border Controller as the Gatekeeper IP address and set
H.323 Settings >
H.323 Call Setup to Gatekeeper.
GATEKEEPER SETTINGS
Requires the following configurations on the video system:
•
H.323 Call Setup: Gatekeeper
•
Gatekeeper Discovery: Manual
Control Panel > AUTHENTICATION MODE
Network > AUTO: If Authentication Mode is set to Auto and the Gatekeeper indicates that it requires authentication, the
endpoint will automatically try to authenticate itself to the Gatekeeper.
LAN Settings >
OFF: If Authentication Mode is set to Off the system will not try to authenticate itself to a Gatekeeper, but will
H.323 Settings >
still try a normal registration.
GATEKEEPER SETTINGS
Control Panel > AUTHENTICATION ID & AUTHENTICATION PASSWORD
Network > The system sends the Authentication ID and the Authentication Password to a Gatekeeper for authentication.
Requires that the Authentication Mode is set to Auto. The authentication is a one way authentication from the
LAN Settings >
endpoint system to a Gatekeeper, i.e. the endpoint is authenticated to the Gatekeeper.
H.323 Settings >
If the Gatekeeper indicates that no authentication is required, the endpoint will still try to register.
GATEKEEPER SETTINGS
D14033.06—AUGUST 2010
Getting started The menu structure The settings library The settings library Using the system Physical interfaces Peripheral equipment
INFORMATION
H.323 is an umbrella recommendation from the ITU-T, that
defines the protocols to provide audio-visual communication
sessions on any packet network.
Administrator Guide
Appendices Contact us
PRODUCT
All MXP
systems
All MXP
systems
All MXP
systems
All MXP
systems
212