TANDBERG MXP F8 Administrator's Manual page 218

MXP
Contents Introduction
MENU ADDRESS SETTINGS DESCRIPTION
Control Panel > USE KEY
Network > Select which of the keys shown below you want to use.
LAN Settings > The key you select must have a valid Encryption Key, or no data will be transmitted. Contact your network
administrator to get a valid encryption key.
Wireless LAN Settings >
ENCRYPTION
KEY 1-4
Control Panel >
Enter the WEP encryption keys for your Wireless LAN connection.
Network >
LAN Settings > Encryption using characters
Wireless LAN Settings > The 64-bit keys can consist of a leading star (*) and 5 characters.
Example: "*mykey"
ENCRYPTION
The 128-bit key can consist of a leading star (*) and 13 characters. Start with a * and then the text.
Example: "*secretkeyhome"
Encryption using Hexadecimal Numbers
The 64-bit keys can consist of 10 hexadecimal digits.
Example: "de01ad4dbe"
The 128-bit key can consist of 26 hexadecimal digits.
Example: "de01ad4dbede01ad4dbede01ad"
Control Panel > SNMP TRAP HOST
Network > Identifies the IP-address of the SNMP Manager. SNMP is used to monitor and configure different entities in a
network, like routers, servers, switches, projectors, etc.
LAN Settings >
The system's SNMP Agent (in the codec) responds to requests from SNMP Managers (a PC program etc.).
SNMP SETTINGS
SNMP Traps are generated by the SNMP Agent to inform the SNMP Manager about important events.
Can be used to send event created messages to the SNMP agent about different events like: system reboot,
system dialing, system disconnecting, MCU call, packet loss etc. Traps can be sent to multiple SNMP Trap
Hosts. Enter the IP address of up to three SNMP Managers. All traps will then be sent to the hosts listed.
To monitor you can use TMS, or other types of SNMP agents like HP OpenView. By using the SNMP agent,
you can send SNMP packets to the unit to configure the system. However TANDBERG will only allow a
couple of things to be configured like: Contact name, location and system name.
Control Panel > SNMP COMMUNITY
Network > SNMP Community names are used to authenticate SNMP requests. SNMP requests must have a 'password'
(case sensitive) in order to receive a response from the SNMP Agent in the codec.
LAN Settings >
The default password is "public"
SNMP SETTINGS
D14033.06—AUGUST 2010
Getting started The menu structure The settings library The settings library Using the system Physical interfaces Peripheral equipment
INFORMATION
NOTE: An endpoint will find the access point if the SSID
is correct, however if the encryption key is faulty it will not
transmit any data.
NOTE: An endpoint will find the access point if the SSID
is correct, however if the encryption key is faulty it will not
transmit any data.
SNMP - Simple Network Management Protocol, SNMP Ver 1.
If you have the TANDBERG Management Suite (TMS) you must
make sure the same SNMP Community is configured there too.
NOTE! The SNMP Community ('password') is case sensitive.
Administrator Guide
Appendices Contact us
PRODUCT
All MXP
systems
with WLAN
All MXP
systems
with WLAN
All MXP
systems
All MXP
systems
218