TANDBERG MXP F8 Administrator's Manual page 194

MXP
Contents Introduction
MENU ADDRESS SETTINGS DESCRIPTION
Control Panel > OUTPUT LEVEL SETTINGS - OUT 1-3
Audio > Applies to: 8000 MXP, 6000 MXP Profile, Maestro MXP
Audio Outputs > Adjust the audio output levels according to the parameters of the external audio equipment connected.
These levels should only be adjusted when installing new audio equipment. The default settings are correct
LEVEL SETTINGS
for the TANDBERG Digital Natural Audio Module (DNAM) and for most consumer electronics devices
(televisions, VCRs, etc.). Use the volume keys on the remote control to adjust the level of output 1 (the
speaker output). The volume control has no effect on other outputs.
OUT1: is intended for connection to TANDBERG Digital Natural Audio Module, televisions or audio amplifiers.
Set the maximum level. The nominal level is -10,0 dBu.
OUT2 (AUX): is intended for connection to audio recording equipment or to a telephone add-on hybrid. The
signal is a mix of audio from both the far end and local end (not from Audio in 5).
Set the maximum level. The nominal level is -10,0 dBu.
OUT3 (VCR): is intended for connection to a VCR or other recording equipment. The signal is a mix of audio
from far end and local end (not from Audio in 6).
Set the maximum level. The nominal level is -10,0 dBu.
Control Panel > OUTPUT LEVEL SETTINGS - OUT 1-2*
Audio > Applies to: 3000 MXP Profile, Tactical MXP, 990/880/770 MXP, 550 MXP, Edge 95/85/75 MXP
Audio Outputs > Adjust the audio output levels according to the parameters of the external audio equipment connected.
These levels should only be adjusted when installing new audio equipment. The default settings are correct
LEVEL SETTINGS
for the TANDBERG Digital Natural Audio module and for most consumer electronics devices (televisions,
VCRs, etc.). The volume keys on the remote control adjust the level of output 1 (the speaker output). The
volume control has no effect on other outputs..
OUT1: is intended for connection to televisions or audio amplifiers.
Set the maximum level. The nominal level is -10,0 dBu.
OUT2 (AUX): is intended for connection to a VCR or other recording equipment. The signal is a mix of audio
from far end and local end (except VCR in).
Set the maximum level. The nominal level is -10,0 dBu.
D14033.06—AUGUST 2010
Getting started The menu structure The settings library The settings library Using the system Physical interfaces Peripheral equipment
INFORMATION
See the Interfaces
more information on this topic for your product.
When no audio module is detected, audio outputs can be:
•
Out 2 for VCR Left
•
Out 3 for VCR Right.
See the Interfaces
more information on this topic for your product.
When no audio module is detected, audio outputs can be:
•
Out 1 for VCR Left
•
Out 2 for VCR Right.
* TANDBERG 550 MXP has one Audio Output (see Out1).
Administrator Guide
Appendices Contact us
in the PERIPHERAL EQUIPMENT section for
in the PERIPHERAL EQUIPMENT section for
PRODUCT
8000
6000
Maestro
3000
Tactical
990/880/
770
550
95/85/75
194