Auto-Qos Configuration Example - Cisco 3020 - Catalyst Blade Switch Configuration Manual

Chapter 27 Configuring QoS

Auto-QoS Configuration Example

This section describes how you could implement auto-QoS in a network, as shown in
optimum QoS performance, enable auto-QoS on all the devices in the network.
Figure 27-11
Figure 27-11
enabled on the switches in the wiring closets at the edge of the QoS domain.
OL-8915-01
Auto-QoS Configuration Example Network
Blade Server
Blade Server
Identify this interface
as connected to a
trusted switch or router
Catalyst 2970
IP
Identify these
interfaces as
connected to
IP
IP phones
Cisco IP phones
shows a network in which the VoIP traffic is prioritized over all other traffic. Auto-QoS is
Cisco router
Trunk Trunk
link link
Catalyst 3750
Cisco blade
switch switch
Catalyst 3560
switch
switch
Identify these
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Configuring Auto-QoS
To Internet
Video server
172.20.10.16
Identify this interface
as connected to a
trusted switch or router
IP
interfaces as
connected to
IP
IP phones
Cisco IP phones
Figure 27-11. For
27-27