Auto-Qos Configuration Example - Cisco Catalyst 3750 Software Configuration Manual

Chapter 26 Configuring QoS

Auto-QoS Configuration Example

This section describes how you could implement auto-QoS in a network, as shown in
Figure 26-12 Auto-QoS Configuration Example Network
Figure 26-12
enabled on the switches in the wiring closets at the edge of the QoS domains.
You should not configure any standard QoS commands before entering the auto-QoS commands. You
Note
can fine-tune the QoS configuration, but we recommend that you do so only after the auto-QoS
configuration is completed.
78-15870-01
End stations
Identify this interface
as connected to a
trusted switch or router
IP
Identify these
interfaces as
connected to
IP
IP phones
Cisco IP phones
shows a network in which the VoIP traffic is prioritized over all other traffic. Auto-QoS is
Cisco router
To Internet
Trunk Trunk
link link
Identify these
interfaces as
connected to
IP phones
Catalyst 3750 Metro Switch Software Configuration Guide
Configuring Auto-QoS
Figure
Video server
172.20.10.16
Identify this interface
as connected to a
trusted switch or router
IP
IP
Cisco IP phones
26-12.
26-35