Upgrading The Client Adapter Software; Uninstalling The Client Adapter Software - Cisco AIR-PCI340 Installation And Configuration Manual

Client Adapter Software Procedures

Upgrading the Client Adapter Software

The same procedure that is used to initially install client adapter software can also be used to upgrade to
a more recent version. Refer to
Note The client adapter's firmware can also be upgraded through ACU. Refer to the
Firmware" section on page 9-8

Uninstalling the Client Adapter Software

This section provides instructions for uninstalling any Cisco Aironet client adapter drivers, utilities, and
security modules that are installed on your computer. Only the client adapter's firmware remains
installed. This procedure is necessary if you want to remove any installed client adapter software
components from your computer or downgrade to previous versions.
If you want to downgrade to earlier versions of client adapter software, follow the steps below to
Note
uninstall the current software components. Then install the older software.
When you uninstall the client adapter software, any existing profiles are removed. If you want to save
Note
your profiles for later use, follow the instructions in
the software components.
This procedure does not uninstall the PC, LM, or PCI card driver that was bundled with Windows Me
Note
and XP. It uninstalls only drivers to which you have upgraded. When you follow the steps below to
uninstall an upgraded driver and then eject and reinsert the card, Windows finds the original driver and
reinstalls it automatically.
Step 1 Perform one of the following:
•
•
Select Start > Run.
Step 2
Browse to the location of the Install Wizard software, select the IWSetup.exe file, and click Open and
Step 3
OK.
The Cisco Aironet Wireless LAN Client Adapter Installation Wizard screen appears (see
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
9-6
If you want to remove the client adapter from your computer, shut down your computer, remove the
client adapter, and reboot your computer.
If you want to leave your client adapter inserted in your computer or if your client adapter is an LM
or mini PCI card and cannot be removed, go to
Chapter 3 for instructions on upgrading your client adapter's software.
for details.
Chapter 4
Step 2.
Chapter 9 Routine Procedures
"Upgrading the
to export your profiles before uninstalling
Figure 9-3).
OL-1394-07