Verifying Installation; Deciding How To Configure Your Client Adapter (Windows Xp Only) - Cisco AIR-PCI340 Installation And Configuration Manual

Verifying Installation

Step 26 If you want to install a second client adapter, allow your computer to completely reboot; then repeat the
steps in this section for the second adapter.
Note
Step 27 Go to the
verify installation, go to
Verifying Installation
To verify that you have properly installed the client adapter software, check the client adapter's LEDs.
If the installation was successful, the client adapter's green LED blinks.
If your installation was unsuccessful or you experienced problems during or after installation, refer to
Note
Chapter 10
Now that your client adapter is properly installed, you are ready to go to
your client adapter, unless you are running Windows XP or have more than one client adapter installed.
•
•
Deciding How to Configure Your Client Adapter
(Windows XP Only)
Windows XP is the only operating system that enables you to configure your client adapter without using
ACU. Therefore, if your computer is running Windows XP, you must decide whether to configure your
client adapter through Windows XP or ACU. To help you with your decision,
Windows XP and ACU client adapter features.
Table 3-3
Feature
Configuration parameters
Capabilities
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
3-22
In Step 13, find the Install Wizard files using Windows Explorer. Then double-click the
IWSetup.exe file.
"Verifying Installation"
Chapter 4
for a list of installation error messages and troubleshooting information.
If you are running Windows XP, go to the
(Windows XP Only)" section below.
If you have more than one client adapter installed, go to the
Client Adapters" section on page
Comparison of Windows XP and ACU Client Adapter Features
Create profiles
Upgrade radio firmware
Restart client adapter without
rebooting or ejecting card
Turn radio on or off
section below to determine if the installation was successful. After you
if you want to create profiles for your client adapter.
"Deciding How to Configure Your Client Adapter
3-24.
Windows XP
Limited
No
No
No
No
Chapter 3 Installing the Client Adapter
Chapter 4 to create profiles for
"Selecting Among Several Installed
Table 3-3 compares the
ACU
Extensive
Yes
Yes
Yes
Yes
OL-1394-07