Manually Installing Or Upgrading The Client Adapter Driver - Cisco Aironet CB21AG Installation And Configuration Manual

Installing the Client Adapter Software
Figure 3-10
Choose one of the following options and click Next:
Step 20
Note
Install Client Utilities and Driver—Installs the client adapter driver and client utilities.
•
Install Driver Only—Installs only the client adapter driver. If you choose this option, click Next
•
and go to
• Make Driver Installation Diskette(s)—Enables you to create driver installation diskettes that can
be used to install drivers using the Windows Device Manager.
Note
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
3-12
Setup Type Window
To ensure compatibility among software components, Cisco recommends that you install the
client utilities and driver.
Step 32.
If you choose one of the first two options and a client adapter is not inserted into your computer,
the following message appears: "The device may not be present or could have been
ejected/unplugged from the system. Insert or reinsert it now." Insert the client adapter and click
OK. If you proceed without the client adapter inserted, the installation continues, but the driver
installation is incomplete. You must manually install the driver later using the Update Device
Driver Wizard. See the "Manually Installing or Upgrading the Client Adapter Driver" section on
page 9-6 for instructions.
Chapter 3 Installing the Client Adapter
OL-4211-05