Using Static Wep; Entering A New Static Wep Key - Cisco AIR-PCI340 Installation And Configuration Manual

Setting Network Security Parameters
Table 5-6
Security Feature
Fast roaming (CCKM)
Reporting access points
that fail LEAP
authentication
MIC
TKIP
Broadcast key rotation

Using Static WEP

This section provides instructions for entering new static WEP keys or overwriting existing static WEP
keys.

Entering a New Static WEP Key

Follow the steps below to enter a new static WEP key for this profile.
Select None under Network Authentication on the Network Security screen.
Step 1
Select Static WEP under Data Encryption.
Step 2
Click the Static WEP Keys button. The Static WEP Keys screen appears (see
Step 3
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
5-32
Client and Access Point Security Settings (continued)
Client Setting
Enable LEAP and select Allow Fast
Roaming (CCKM)
No settings required; automatically
enabled in firmware version
5.02.20 or greater
No settings required; automatically
enabled by the driver included in
the Install Wizard file
No settings required; automatically
enabled by the firmware included
in the Install Wizard file
Enable LEAP, EAP-TLS, PEAP, or
EAP-SIM and use the firmware
included in the Install Wizard file
Chapter 5 Configuring the Client Adapter
Access Point Setting
Use firmware version 12.2(11)JA
or greater, select a cipher suite that
is compatible with CCKM, and
enable Network-EAP and CCKM
for the SSID
Note To allow both 802.1X
clients and non-802.1X
clients to use the SSID,
enable optional CCKM.
No settings required; automatically
enabled in the following firmware
versions: 12.00T or greater (340,
350, and 1200 series access points)
or Cisco IOS Release 12.2(4)JA or
greater (1100 series access points)
Set up and enable WEP with full
encryption, set MIC to MMH or
select Enable MIC check box, and
set Use Aironet Extensions to Yes
Set up and enable WEP, set TKIP to
Cisco or select Enable Per Packet
Keying check box, and set Use
Aironet Extensions to Yes
Set up and enable WEP and set
Broadcast WEP Key Rotation
Interval to any value other than
zero (0)
Figure 5-6).
OL-1394-07